Robinair Transmission Fluid Exchanger 92500 User Manual download pdf (Page 13)

Transmission Fluid Exchanger

1111

1111

11

Operating Procedures

Cooler Only Mode

continued

Check the ATF Level in the Pan

1. Remove the dipstick to check level of fluid in

transmission fluid pan. If the vehicle does not

have a dipstick, refer to the vehicle’s service

manual for the method required to check the

fluid level.

If the fluid level needs to be adjusted, continue

on to “Adjust the ATF Level.” If the level is

satisfactory, go to step 4 under “Adjust the ATF

Level.”

Adjust the ATF Level

1. Press ENTER. The

To Trans

,

From Trans

and

Finish

LEDs light.

a. If the level is too low, select

To Trans

LED. Press ENTER. Press the up arrow key

to select how much fluid to add (each press

indicates one-tenth of a quart).

b. If the level is too high, select

From Trans

LED. Press ENTER. Press the up arrow key

to select how much fluid to take out (each

press indicates one-tenth of a quart).

2. When transfer is complete, go to “Check the

ATF Level in the Pan.”

3. If the level is satisfactory, press SELECT

until

Finish

LED lights.

a. Wait for one second.

b. Press ENTER to confirm the function.

c. Press ENTER again.

The display reads SR FIN, indicating the service

is finished.

Manual/Top-Off Mode

Transfers used ATF and new ATF through the

transmission’s dipstick tube. This mode is

commonly used when the transmission fluid pan

needs to be removed (to change gaskets or

replace a filter). When using another mode, this

mode is required to top off the ATF fluid level.

Note: Confirm vehicle and transmission are at

operating temperature before initiating service.

Power Up

1. Connect the power cord to a 12V DC

battery: red to the positive post and black to

the negative post.

2. Remove the dipstick from the transmission

noting ATF level, which will determine

whether additional ATF needs to be added

or withdrawn.

3. Turn the unit on. The

Reversed Polarity

LED

lights if the power is connected incorrectly.

The unit self-tests: The buzzer sounds, all

LEDS and displays light and flash, the

flexible nylon hose evacuates ATF, and the

software version displays.

4. Insert the unit’s flexible nylon transfer hose

into the transmission dipstick tube as far as

possible to reach the bottom of the oil pan.

5. Press the SELECT button until only the

Manual/Top-Off

LED is lit and flashing.

6. Pause until the ENTER LED lights and

flashes (about one second).

7. Press ENTER to confirm the selection. The

Check Trans Level

,

To Trans,

and

From

Trans

LEDs light

. Drn Pan

appears on the

display.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Comments to this Manuals

No comments