© 2004 SPX Corporation
66
66
6
Operating Procedures
Dipstick Only Mode
The Dipstick Only mode transfers used ATF and
new ATF through the transmission’s dipstick
tube by running a hose into the transmission
fluid pan, emptying it of its contents, and then
with engine running, adding ATF. ATF is then
subtracted until a user specified amount of new
ATF has been added.
Note: Confirm vehicle and transmission are at
operating temperature before initiating service.
Power Up
1. Connect the power cord to a 12V DC
battery: red to the positive post and black to
the negative post.
2. Turn the unit on. The
Reversed Polarity
LED
lights if the power is connected incorrectly.
The unit self-tests: The buzzer sounds, all
LEDS and displays light, the flexible nylon
hose evacuates ATF, and the software
version displays.
3. Remove dipstick from the transmission tube.
4. Insert the unit’s flexible nylon hose into the
transmission dipstick tube as far as possible
to reach the bottom of the oil pan. The
Dipstick Only, Dipstick/Cooler, Cooler Only,
Manual/Top-Off, Drain Waste Tank, and
Total Count
indicators, and the
SELECT
button LEDs are still lit and flashing.
5. Press the SELECT button until the
Dipstick
Only
LED is lit.
6. Pause until the ENTER LED lights and
flashes (about one second).
7. Press ENTER to confirm the selection. The
left display (
New Fluid In
) reads 12 (the
default quantity in quarts of new ATF to be
run into the system).
8. Use the arrow keys to select the amount of
quarts to be transferred. (12 quarts is the
default; minimum is 6 quarts, maximum is 32
quarts.)
9. Press ENTER to confirm the quantity
displayed. The alarm sounds, and the
Start
Service
and ENTER LEDs flash.
Start Service
1. With the vehicle engine off, press ENTER to
start the ATF exchange. The following takes
place:
a. The unit purges its internal fluid lines.
b. Used ATF is then extracted from the
transmission pan until empty.
c. The cumulative volume extracted
appears
on the
Replace Fluid Out
display.
d. Through the nylon transfer hose, the unit
pumps back into the transmission fluid pan
the same volume of new ATF that appears
on the
Replace Fluid Out
display.
e. The volume of new fluid yet to be pumped
into the transmission pan is shown on
New
Fluid In
display. (The amount designated in
“Power Up” step 8 minus the amount
transferred in “Start Service” step 1d.)
f. The
Start Engine
and ENTER LEDs flash.
2. Start the vehicle’s engine to circulate the new
ATF through the transmission system (torque
converter and cooler lines).
3. Press ENTER to confirm the engine is
running.
The exchanger extracts one quart of diluted ATF
and returns one quart of new ATF through the
hose and back into the transmission fluid pan.
The
Replace Fluid Out
and
New Fluid In
displays
respectively the amount of fluid extracted and
the amount of new fluid to be added. This
recycling continues until the selection made in
step 8 under “Power Up” is met (i.e., using the
12 quart default,
Replace Fluid Out
will be 12
and
New Fluid In
will be 0).
(9 pages)
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals